Materials list for a 16x16 deck
For a deck 16 feet along the house and 16 feet out, with 5.5 inch boards, a 1/8 inch gap, joists 16 inches on center and 10 percent waste. Change any of it in the calculator above.
| Item | Quantity | Cost |
|---|---|---|
| Deck boards, 5.5 in wide | 39 boards, 16 ft long | $593 |
| Joists | 13 boards, 16 ft long | $443 |
| Ledger and rim board | 2 boards, 16 ft long | $68 |
| Beam boards | 4 boards, 16 ft long | $136 |
| Posts | 6 | $255 |
| Footings | 6 | Not priced |
| Joist hangers | 13 | $44 |
| Deck screws | About 1,001, in 2 boxes of 1,000 | $82 |
| Total | About $1,621 |
Prices are store prices checked in October 2026, with all framing priced as treated 2x10 at $2.13 a foot. Change any price in the calculator to match your quote.
For the one-beam frame the joists are 16 foot 2x12s, the heaviest pieces in the job. Deck boards, ledger, rim and beam are 16 foot stock too, so the whole order is one length.
What a 16x16 deck costs
About $1,621 in lumber and hardware, or $6 per square foot, before concrete, railing, stairs, flashing, stain and tax. HomeAdvisor puts labor at $15 to $35 per square foot, so a contractor-built 16x16 comes to about $5,461 to $10,581. Compare cedar and composite boards in the deck cost calculator.
What fits on a 16x16 deck
A 16x16 deck is the first square size here big enough for a table for eight with a grill. At 256 square feet it also fits a table for six, a grill and two lounge chairs.
Counting room to pull out chairs and walk past, a 16x16 deck holds a table for eight (14 by 10 feet) and a grill with room to cook (5 by 5 feet). Set up for lounging instead, it holds a sofa, two chairs and a low table (10 by 8 feet) and a grill with room to cook (5 by 5 feet). These are rough planning sizes, so measure your own furniture.
Square decks are easy to divide from the corners. Put the stairs at a corner away from the door, so the path runs along one edge and the middle stays free for the table.
The next size up, 14x20, adds 24 square feet: room for two lounge chairs; 2x10 joists instead of 2x12s; a beam of two 2x12s instead of a three-ply one.
Framing a 16x16 deck
Joists run out from the house: 13 of them at 16 inches on center, each 16 feet long. The list frames the deck with two beams, one near the middle and one at the outer edge, so each joist spans about 8 feet. DCA 6 does not cover that layout, because its beam and footing tables are for a beam carrying a single span of joists, and a middle beam carries joists on both sides. One beam at the outer edge keeps the deck inside the guide, and the table gives the smallest joist DCA 6 allows for that full 16 foot span.
| Species | 12 in on center | 16 in on center | 24 in on center |
|---|---|---|---|
| Southern Pine | 2x10 | 2x12 | None |
| Douglas fir-larch, hem-fir, spruce-pine-fir | 2x12 | None | None |
| Redwood, western cedar | 2x12 | None | None |
In Southern Pine at 16 inches, that is a 2x12. The ledger, and any joist or rim a railing post bolts to, must be at least 2x8.
With one beam at the outer edge, 3 posts no more than 8 feet apart put the beam span at 8 feet. At a 16 foot joist span, DCA 6 Table 3A has no two-ply beam that reaches; the smallest that does is three 2x12s, allowed 9 ft 1 in. A fourth post cuts the span to 5 ft 4 in, where two 2x10s are enough. The list prices two 2x10s, which fall short at this span, so upgrade the beam or add the post.
For a 16 foot joist span, DCA 6 Table 5 puts 1/2 inch lag screws every 11 inches into a solid lumber band joist, about 19 along this 16 foot ledger, or through-bolts every 21 inches, about 11. No lead anchors, and no ledger on brick or stone veneer.
A 16 foot deep deck is where the frame choice matters most. Two beams keep every joist short but put the middle beam outside DCA 6. One beam keeps the deck inside the guide, at the price of 2x12 joists and a heavier beam.
Deck boards on a 16x16 deck
35 rows of boards run along the house, across the joists. Each row is a single 16 foot board, so there are no joints to line up over joists. Laid on a diagonal, 5/4 wood boards need joists 12 inches apart, not 16: 17 joists instead of 13.
Railing and stairs
More than 30 inches up, a railing is required: 48 feet on the three open sides, about 10 railing posts and 108 balusters 1.5 inches wide, less the stair opening. See the baluster and stair calculators.
Footings and concrete
DCA 6 Table 4, for 16 foot joists and 8 feet between posts: footings 27 inches round or 24 inches square, 11 inches thick, on soil that bears 1,500 psf, under Southern Pine 6x6 posts up to 14 feet tall. Poured as a pad with a 12 inch pier up to the ground in 36 inch holes, the 3 beam footings take about 30 bags of 80 lb mix with 10 percent extra. That is for the one-beam frame; footings for the two-beam layout in the list come from your building department. Your frost line may call for deeper holes; the concrete footing calculator redoes the count.
Permits and code limits
Under the model code, only a deck of 200 square feet or less, no more than 30 inches up, not attached to the house and not serving the main exit door skips the permit. This deck bolts to the house, and at 256 square feet it is over the size limit too, so even a freestanding version would need a permit. Local rules vary, so ask your building department.
DCA 6 only covers decks that stick out from the house no farther than they run along it. A square 16x16 sits exactly at that limit. It also leaves out decks with snow loads over 40 psf, and hot tubs: water 3 feet deep weighs about 187 pounds per square foot, against the 40 psf live load its tables assume.
Before you build a 16x16 deck
Sixteen feet out from the house the ground is often lower than at the wall, so measure post heights at the outer beam before ordering. DCA 6 Table 4 caps Southern Pine 6x6 posts at 14 feet for the one-beam frame here, and railing is required wherever the floor is more than 30 inches above the ground.
Other deck sizes
8x1010x1010x1212x1212x1412x1612x2014x1614x2016x1616x2020x20
Common questions
How many deck boards do I need for a 16x16 deck?
39 boards 16 feet long: 35 rows of 5.5 inch boards, plus 10 percent waste.
How many joists do I need for a 16x16 deck?
13 joists 16 feet long at 16 inches on center, counting the two end joists.
How many screws do I need for a 16x16 deck?
About 1,001, two wherever a board crosses a joist, plus 10 percent.
How much does a 16x16 deck cost in materials?
About $1,621 in pressure-treated lumber and hardware, or $5,461 to $10,581 built by a contractor.
Does a 16x16 deck need two beams?
Not always. In Southern Pine, 2x12 joists at 16 inches on center span 16 ft 6 in in DCA 6, so one beam at the outer edge can carry a 16 foot deep deck. Douglas fir, hem-fir and spruce-pine-fir 2x12s reach 15 ft 9 in at 16 inches, so they need 12 inch spacing. Two beams shorten the joists but fall outside the guide's beam tables.
What size beam for a 16x16 deck with one beam?
Carrying 16 foot joists, DCA 6 needs three Southern Pine 2x12s on three posts 8 feet apart. With four posts, about 5 ft 4 in apart, two 2x10s are enough.
Tools for this job
Each link opens an Amazon search for that item. As an Amazon Associate I earn from qualifying purchases.
- Chalk line. Snaps a straight line for the first board and for trimming the board ends.
- Speed square. Marks square cuts on deck boards and joists.
- Deck board spacers. Keep the same gap between every board.
- Deck board straightening tool. Pulls a bowed board tight while you screw it down.
- Joist tape. Covers the tops of the joists so water does not sit on the wood.
- Driver bits. Spares for the drill, because deck screws wear bits out fast.
Sources
- International Residential Code 2021, Chapter 5: decks (R507)
- American Wood Council, DCA 6: Prescriptive Residential Wood Deck Construction Guide
- International Residential Code 2021, Chapter 3: landings and stairs (R311.3, R311.7) and guards (R312)
- International Residential Code 2021, Chapter 1: work exempt from permit (R105.2)
- McCoy's Building Supply: deck board prices, treated pine and composite
- McCoy's Building Supply: pressure-treated lumber and post prices
- McCoy's Building Supply: Simpson Strong-Tie LUS210Z joist hanger
- McCoy's Building Supply: deck screws, #10 x 2-1/2 in, box of 1,000
- HomeAdvisor: cost to build a deck, with labor rates
Facts on this page were last checked against these sources in October 2026.